Wireless Motion Sensor Night Lights White LED (Rechargeable)

Features:

1. The light source is LED, the length is different, and the quantity of led bead is different;

2. The install method is magnetic suction type. Tear off the adhesive on the back of the iron sheet and stick it on the wall or cabinet, and stick magnet strip onto the back of the lamp. The induction lamp can be sucked with the magnet and iron sheet.

Specification:

Name: LED Sensor Light

Length: 10cm-6 Led-1W，20cm-13 Led-2W，30cm-21 Led-3W

Lighting Color: Warm White(2800-3200K) / Cool White(6000-7000K)

Voltage: DC5V

Note:

1. Please charge before use.

2. Please put away from fire or Explosive goods.

3. Children must be use under adult's guidance.

Function introduction:

1、Charge before use

2、No wire required,easy assembly,can be used for bedroom,wardrobe,cabinet,stairs,balcony,carriage etc.

3、If the environment bright enough the lamp will stop work,if darker than 10Lux will work again while there has people around 0-6 meters.And will turn off again after you leave 20 seconds later.

4、Good lithium battery inside,will glitter while charging.And will turn red after full charge.(or be red while charging and stop after full charged).Can be charge via mobile phone's 5V charge or USB by computer.Can't charge over than 5V.

5、There has a magnetic sheet under the bottom,and be absorb on the surface of iron.Also can use the irons whice attached with products (it has glue so can be use on any flat surface)

Note: in order to protect battery,please charge timely while it getting darker.

Installation method:

*Install the magnet and stainless steel sheet in turn according to the figure.

*Tear the adhesive film on the stainless steel sheet.

*Aim at the place where you want to install it,stick it up and press it tightly.

*You can always take it off when you went to charge it.

*The following image is a warm light real shot.

*The following image is a white light real-life shot.